Busy Bee Lathe

From Freeside Atlanta
Revision as of 06:04, 6 October 2013 by Mekcrab (talk | contribs) (fleshing out full page details)
Jump to navigation Jump to search

Owner(s)

  • This page in progress 10-6-2013
  • ???

Permissions

In this optional section, specify the conditions for permission to use the machine, if any.

Restrictions

  • Do not run lathe if oil level below 'low' on sightglass. add pic
  • Test emergency foot brake before use
  • NEVER EVER EVER attempt to change spindle speeds while machine is running
  • Example: do not run lathe while X or Y machine is also running in the area
  • Example: only use lathe in the presence of another member

About

Mechanical Controls

need labeled picture of headstock and apron controls

Setting Spindle Speed

add table See also: [1]

Lubrication System

controls specs, lube type, does the lube pump even work?

Electrical

put up edited CT089 schematic here

Manual(s)

Instruction and Safety Articles

Projects

The lathe is down for some electrical repairs, week of 10-6-2013

Single point threading drive and apron controls need to be refurbished and (re)installed.