Difference between revisions of "Busy Bee Lathe"

From Freeside Atlanta
Jump to navigation Jump to search
(fleshing out full page details)
Line 1: Line 1:
= Owner(s) =
= Owner(s) =
* This page in progress 10-6-2013
* ???
* ???


Line 6: Line 7:


= Restrictions =
= Restrictions =
In this optional section, specify any restrictions on use
* Do not run lathe if oil level below 'low' on sightglass. ''add pic''
* Test emergency foot brake before use
* NEVER EVER EVER attempt to change spindle speeds while machine is running
 
* Example: do not run lathe while X or Y machine is also running in the area
* Example: do not run lathe while X or Y machine is also running in the area
* Example: only use lath in the presence of another member
* Example: only use lathe in the presence of another member


= About =
= About =
* [http://www.busybeetools.com/products/LATHE-14IN.-X-40IN.-3HP-220V-1-PHASE.html Specifications]
* [http://www.busybeetools.com/products/LATHE-14IN.-X-40IN.-3HP-220V-1-PHASE.html Specifications]
== Mechanical Controls ==
''need labeled picture of headstock and apron controls''
=== Setting Spindle Speed ===
''add table ''
See also: [http://en.wikipedia.org/wiki/Speeds_and_feeds]
=== Lubrication System ===
'' controls specs, lube type, does the lube pump even work? ''
== Electrical ==
''put up edited CT089 schematic here ''


= Manual(s) =
= Manual(s) =
* [http://busybeetools.com/product_manuals/CT042.pdf CT042]
* [http://busybeetools.com/product_manuals/CT042.pdf CT042]
* [http://busybeetools.com/product_manuals/CT089.pdf CT089]
* [http://busybeetools.com/product_manuals/CT089.pdf CT089] <-- most similar to our model


= Instruction and Safety Articles =
= Instruction and Safety Articles =
Line 23: Line 39:


= Projects =
= Projects =
Describe or indicate projects that are using the lathe...
The lathe is down for some electrical repairs, week of 10-6-2013
 
Single point threading drive and apron controls need to be refurbished and (re)installed.

Revision as of 06:04, 6 October 2013

Owner(s)

  • This page in progress 10-6-2013
  • ???

Permissions

In this optional section, specify the conditions for permission to use the machine, if any.

Restrictions

  • Do not run lathe if oil level below 'low' on sightglass. add pic
  • Test emergency foot brake before use
  • NEVER EVER EVER attempt to change spindle speeds while machine is running
  • Example: do not run lathe while X or Y machine is also running in the area
  • Example: only use lathe in the presence of another member

About

Mechanical Controls

need labeled picture of headstock and apron controls

Setting Spindle Speed

add table See also: [1]

Lubrication System

controls specs, lube type, does the lube pump even work?

Electrical

put up edited CT089 schematic here

Manual(s)

Instruction and Safety Articles

Projects

The lathe is down for some electrical repairs, week of 10-6-2013

Single point threading drive and apron controls need to be refurbished and (re)installed.