Difference between revisions of "Busy Bee Lathe"
Jump to navigation
Jump to search
m |
(fixed manual reference) |
||
| Line 18: | Line 18: | ||
=== Setting Spindle Speed === | === Setting Spindle Speed === | ||
''add table '' | ''add table '' | ||
See also: [http://en.wikipedia.org/wiki/Speeds_and_feeds] | See also: [http://en.wikipedia.org/wiki/Speeds_and_feeds Speeds and Feeds] | ||
=== Lubrication System === | === Lubrication System === | ||
| Line 24: | Line 24: | ||
== Electrical == | == Electrical == | ||
''put up edited | ''put up edited CT042 schematic here '' | ||
= Manual(s) = | = Manual(s) = | ||
* [http://busybeetools.com/product_manuals/CT042.pdf CT042] | * [http://busybeetools.com/product_manuals/CT042.pdf CT042] <-- most similar to our model | ||
* [http://busybeetools.com/product_manuals/CT089.pdf CT089] | * [http://busybeetools.com/product_manuals/CT089.pdf CT089] | ||
= Instruction and Safety Articles = | = Instruction and Safety Articles = | ||
Revision as of 06:08, 6 October 2013
Owner(s)
- This page in progress 10-6-2013
- ???
Permissions
In this optional section, specify the conditions for permission to use the machine, if any.
Restrictions
- Do not run lathe if oil level below 'low' on sightglass. add pic
- Test emergency foot brake before use
- NEVER EVER EVER attempt to change spindle speeds while machine is running
About
Mechanical Controls
need labeled picture of headstock and apron controls
Setting Spindle Speed
add table See also: Speeds and Feeds
Lubrication System
controls specs, lube type, does the lube pump even work?
Electrical
put up edited CT042 schematic here
Manual(s)
Instruction and Safety Articles
Projects
The lathe is down for some electrical repairs, week of 10-6-2013
Single point threading drive and apron controls need to be refurbished and (re)installed.