Difference between revisions of "Dye Sublimation Printer"

From Freeside Atlanta
Jump to navigation Jump to search
(Created page with "Artisan 1430 using INKXPRO Dye Sub Ink Owner: Scott McGraw Loanation Terms: *Available for public use. No Training Required *Materials to be paid for by users, not Freeside....")
Line 4: Line 4:
Loanation Terms:  
Loanation Terms:  
*Available for public use. No Training Required
*Available for public use. No Training Required
*Materials to be paid for by users, not Freeside.
*Removal from Freeside to be preceded by min 2 week notice
*Removal from Freeside to be preceded by min 2 week notice
*Damage not covered by Freeside
*Materials not covered by Freeside




Line 22: Line 23:
!Don't breath in the fumes!
!Don't breath in the fumes!


Recommend printing oversize, and cutting aluminum to size with bandsaw beforehand. Sand edges after cutting. Otherwise some sublimation ink will contaminate the rest of the aluminum.
Recommend printing oversize, and cutting aluminum to size with bandsaw beforehand. Sand edges after cutting. Affix using Kapton Tape to prevent sliding. Let cool before removal of paper to prevent ghost images from sliding.
 
Otherwise some sublimation ink will contaminate the rest of the aluminum.





Revision as of 11:50, 12 January 2017

Artisan 1430 using INKXPRO Dye Sub Ink Owner: Scott McGraw

Loanation Terms:

  • Available for public use. No Training Required
  • Removal from Freeside to be preceded by min 2 week notice
  • Damage not covered by Freeside
  • Materials not covered by Freeside


Usage: Don't break it please. Print using Sawgrass PowerDriver 1430. Need to register to download. Just give them fake info, and a fake serial number.

Usage for Coated Aluminum: Print onto Dye Sub Transfer Paper

Heat Press 400 degrees for 60 seconds.

  • Rubber Mat on bottom, paper on mat, aluminum in middle, Teflon on top.
  • Heat Through Aluminum
  • Teflon prevents errant fumes from contaminating heat press

!Don't breath in the fumes!

Recommend printing oversize, and cutting aluminum to size with bandsaw beforehand. Sand edges after cutting. Affix using Kapton Tape to prevent sliding. Let cool before removal of paper to prevent ghost images from sliding.

Otherwise some sublimation ink will contaminate the rest of the aluminum.


Note: CIS system needs to be slightly elevated. Too Low, and ink drains from cartridges. Too high and ink is pushed through printer nozzles.

Reset ink levels by pressing ink change button, then pressing reset button on cartridges for 3 seconds.