Difference between revisions of "Sheet Metal Brake"

From Freeside Atlanta
Jump to navigation Jump to search
 
Line 1: Line 1:
[[Metal Shop]]
[[File:30inch Metal Brake.jpg|thumb|300px]]


= [[Zone]] =
[[Equipment]] \ [[Warehouse]] \ [[Metal Shop]]
= Owner(s) =
* Freeside
== Permissions ==
For general use by members. Treat equipment as if it were your own and put away as or better than you found it.
Contact owner with questions or issues.
== Restrictions ==
* Metal and bendable sheet goods only. Do not use on wire.
* For up to 18 gauge steel
* For up to 16 gauge aluminum
* Material being bent should be clean and rust free
* The two c-clamps belong with the brake and should be stored with it
= About =
For bending thin sheet metal up to 90 degrees.  
For bending thin sheet metal up to 90 degrees.  


[http://www.harborfreight.com/18-inch-bending-brake-39103.html Harbor Freight 18" Bending Brake]
= Basic Instructions =
Mark or Score metal along the intended bend<br />
Use clamps to secure sheet to bend with the pressing plate on top.<br />
Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.
 
 
== Specifications and Detailed Instructions ==
 
[[File:Info.jpg|50px|link=]][http://www.harborfreight.com/30-inch-bending-brake-67240.html Harbor Freight 30" Bending Brake]<br />
[[File:RTFM.PNG|50px|link=]][http://manuals.harborfreight.com/manuals/67000-67999/67240.pdf PDF Manual]<br />
[[File:Video.jpg|50px|link=]][http://www.youtube.com/watch?v=L8tTs5lO3mM Good YouTube demonstration of this style brake]
 
= Warnings =
 
[[File:Crush.png|100px]] Crush and Pinch Risk
== Safety ==
[[File:Goggles.PNG|100px]] Eye Protection Required
 
 
[[category: Equipment]]

Latest revision as of 14:39, 30 December 2014

30inch Metal Brake.jpg

Zone

Equipment \ Warehouse \ Metal Shop

Owner(s)

  • Freeside

Permissions

For general use by members. Treat equipment as if it were your own and put away as or better than you found it. Contact owner with questions or issues.

Restrictions

  • Metal and bendable sheet goods only. Do not use on wire.
  • For up to 18 gauge steel
  • For up to 16 gauge aluminum
  • Material being bent should be clean and rust free
  • The two c-clamps belong with the brake and should be stored with it

About

For bending thin sheet metal up to 90 degrees.

Basic Instructions

Mark or Score metal along the intended bend
Use clamps to secure sheet to bend with the pressing plate on top.
Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.


Specifications and Detailed Instructions

Info.jpgHarbor Freight 30" Bending Brake
RTFM.PNGPDF Manual
Video.jpgGood YouTube demonstration of this style brake

Warnings

Crush.png Crush and Pinch Risk

Safety

Goggles.PNG Eye Protection Required