Difference between revisions of "Busy Bee Lathe"
Jump to navigation
Jump to search
(fleshing out full page details) |
|||
| Line 1: | Line 1: | ||
= Owner(s) = | = Owner(s) = | ||
* This page in progress 10-6-2013 | |||
* ??? | * ??? | ||
| Line 6: | Line 7: | ||
= Restrictions = | = Restrictions = | ||
* Do not run lathe if oil level below 'low' on sightglass. ''add pic'' | |||
* Test emergency foot brake before use | |||
* NEVER EVER EVER attempt to change spindle speeds while machine is running | |||
* Example: do not run lathe while X or Y machine is also running in the area | * Example: do not run lathe while X or Y machine is also running in the area | ||
* Example: only use | * Example: only use lathe in the presence of another member | ||
= About = | = About = | ||
* [http://www.busybeetools.com/products/LATHE-14IN.-X-40IN.-3HP-220V-1-PHASE.html Specifications] | * [http://www.busybeetools.com/products/LATHE-14IN.-X-40IN.-3HP-220V-1-PHASE.html Specifications] | ||
== Mechanical Controls == | |||
''need labeled picture of headstock and apron controls'' | |||
=== Setting Spindle Speed === | |||
''add table '' | |||
See also: [http://en.wikipedia.org/wiki/Speeds_and_feeds] | |||
=== Lubrication System === | |||
'' controls specs, lube type, does the lube pump even work? '' | |||
== Electrical == | |||
''put up edited CT089 schematic here '' | |||
= Manual(s) = | = Manual(s) = | ||
* [http://busybeetools.com/product_manuals/CT042.pdf CT042] | * [http://busybeetools.com/product_manuals/CT042.pdf CT042] | ||
* [http://busybeetools.com/product_manuals/CT089.pdf CT089] | * [http://busybeetools.com/product_manuals/CT089.pdf CT089] <-- most similar to our model | ||
= Instruction and Safety Articles = | = Instruction and Safety Articles = | ||
| Line 23: | Line 39: | ||
= Projects = | = Projects = | ||
The lathe is down for some electrical repairs, week of 10-6-2013 | |||
Single point threading drive and apron controls need to be refurbished and (re)installed. | |||
Revision as of 06:04, 6 October 2013
Owner(s)
- This page in progress 10-6-2013
- ???
Permissions
In this optional section, specify the conditions for permission to use the machine, if any.
Restrictions
- Do not run lathe if oil level below 'low' on sightglass. add pic
- Test emergency foot brake before use
- NEVER EVER EVER attempt to change spindle speeds while machine is running
- Example: do not run lathe while X or Y machine is also running in the area
- Example: only use lathe in the presence of another member
About
Mechanical Controls
need labeled picture of headstock and apron controls
Setting Spindle Speed
add table See also: [1]
Lubrication System
controls specs, lube type, does the lube pump even work?
Electrical
put up edited CT089 schematic here
Manual(s)
Instruction and Safety Articles
Projects
The lathe is down for some electrical repairs, week of 10-6-2013
Single point threading drive and apron controls need to be refurbished and (re)installed.