Difference between revisions of "Sheet Metal Brake"

Revision as of 23:15, 14 February 2013

For bending sheet metal.

A Harbor Freight 18" Bending Brake http://www.harborfreight.com/18-inch-bending-brake-39103.html

@@ Line 1: / Line 1: @@
-[[File:30inch Metal Brake.jpg|thumb|300px]]
+For bending sheet metal.
-= [[Zone]] =
+A Harbor Freight 18" Bending Brake
-[[Equipment]] \ [[Warehouse]] \ [[Metal Shop]]
+http://www.harborfreight.com/18-inch-bending-brake-39103.html
-= Owner(s) =
-* Freeside
-== Permissions ==
-For general use by members. Treat equipment as if it were your own and put away as or better than you found it.
-Contact owner with questions or issues.
-== Restrictions ==
-* Metal and bendable sheet goods only. Do not use on wire.
-* For up to 18 gauge steel
-* For up to 16 gauge aluminum
-* Material being bent should be clean and rust free
-* The two c-clamps belong with the brake and should be stored with it
-= About =
-For bending thin sheet metal up to 90 degrees.
-= Basic Instructions =
-Mark or Score metal along the intended bend<br />
-Use clamps to secure sheet to bend with the pressing plate on top.<br />
-Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.
-== Specifications and Detailed Instructions ==
-[[File:Info.jpg|50px|link=]][http://www.harborfreight.com/30-inch-bending-brake-67240.html Harbor Freight 30" Bending Brake]<br />
-[[File:RTFM.PNG|50px|link=]][http://manuals.harborfreight.com/manuals/67000-67999/67240.pdf PDF Manual]<br />
-[[File:Video.jpg|50px|link=]][http://www.youtube.com/watch?v=L8tTs5lO3mM Good YouTube demonstration of this style brake]
-= Warnings =
-[[File:Crush.png|100px]] Crush and Pinch Risk
-== Safety ==
-[[File:Goggles.PNG|100px]] Eye Protection Required
-[[category: Equipment]]

Difference between revisions of "Sheet Metal Brake"

Revision as of 23:15, 14 February 2013

Navigation menu

Search