Difference between revisions of "Sheet Metal Brake"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=== [[Equipment]]/[[Metal Shop]] === | |||
= | |||
[[Equipment]] | |||
= Owner(s) = | = Owner(s) = | ||
* | * Randy Farmer | ||
= Permissions = | |||
For general use by members. Treat equipment as if it were your own and put away as or better than you found it. | For general use by members. Treat equipment as if it were your own and put away as, or better than you found it. | ||
Contact owner with questions or issues. | Contact owner with questions or issues. | ||
= Restrictions = | |||
* For up to 18 gauge steel | * For up to 18 gauge steel | ||
* For up to 16 gauge aluminum | * For up to 16 gauge aluminum | ||
= About = | = About = | ||
For bending thin sheet metal up to 90 degrees. | For bending thin sheet metal up to 90 degrees. | ||
[http://www.harborfreight.com/18-inch-bending-brake-39103.html Harbor Freight 18" Bending Brake] | |||
Revision as of 23:24, 14 February 2013
Equipment/Metal Shop
Owner(s)
- Randy Farmer
Permissions
For general use by members. Treat equipment as if it were your own and put away as, or better than you found it. Contact owner with questions or issues.
Restrictions
- For up to 18 gauge steel
- For up to 16 gauge aluminum
About
For bending thin sheet metal up to 90 degrees.