Difference between revisions of "Sheet Metal Brake"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
= [[Zone]] = | = [[Zone]] = | ||
[[Equipment]] \ [[Warehouse]] \ [[Metal Shop]] | [[Equipment]] \ [[Warehouse]] \ [[Metal Shop]] | ||
= Owner(s) = | = Owner(s) = | ||
* | * Randy Farmer | ||
== Permissions == | == Permissions == | ||
For general use by members. Treat equipment as if it were your own and put away as or better than you found it. | For general use by members. Treat equipment as if it were your own and put away as, or better than you found it. | ||
Contact owner with questions or issues. | Contact owner with questions or issues. | ||
== Restrictions == | == Restrictions == | ||
* For up to 18 gauge steel | * For up to 18 gauge steel | ||
* For up to 16 gauge aluminum | * For up to 16 gauge aluminum | ||
| Line 22: | Line 19: | ||
= Basic Instructions = | = Basic Instructions = | ||
Use clamps to secure sheet to bend with the pressing plate on top. Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle. | |||
Use clamps to secure sheet to bend with the pressing plate on top. | |||
Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle. | |||
== Specifications and Detailed Instructions == | |||
[http://www.harborfreight.com/30-inch-bending-brake-67240.html Harbor Freight 30" Bending Brake]<br /> | |||
[http://www.youtube.com/watch?v=L8tTs5lO3mM Good YouTube demonstration of this style brake] | |||
= Warnings = | = Warnings = | ||
[[File:Crush.png| | [[File:Crush.png|border|50px]] Crush and Pinch Risk | ||
== Safety == | == Safety == | ||
[[File:Goggles.PNG| | [[File:Goggles.PNG|border|50px]] Eye Protection Required | ||
[[category: Equipment]] | [[category: Equipment]] | ||
Revision as of 06:22, 15 February 2013
Zone
Equipment \ Warehouse \ Metal Shop
Owner(s)
- Randy Farmer
Permissions
For general use by members. Treat equipment as if it were your own and put away as, or better than you found it. Contact owner with questions or issues.
Restrictions
- For up to 18 gauge steel
- For up to 16 gauge aluminum
- Material being bent should be clean and rust free
- The two c-clamps belong with the brake and should be stored with it
About
For bending thin sheet metal up to 90 degrees.
Basic Instructions
Use clamps to secure sheet to bend with the pressing plate on top. Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.
Specifications and Detailed Instructions
Harbor Freight 30" Bending Brake
Good YouTube demonstration of this style brake
Warnings
Crush and Pinch Risk
Safety
Eye Protection Required