Difference between revisions of "Sheet Metal Brake"

From Freeside Atlanta
Jump to navigation Jump to search
Line 1: Line 1:
[[File:30inch Metal Brake.jpg|thumb|300px]]
= [[Zone]] =
= [[Zone]] =
[[Equipment]] \ [[Warehouse]] \ [[Metal Shop]]
[[Equipment]] \ [[Warehouse]] \ [[Metal Shop]]


= Owner(s) =
= Owner(s) =
* Freeside
* Randy Farmer


== Permissions ==
== Permissions ==
For general use by members. Treat equipment as if it were your own and put away as or better than you found it.  
For general use by members. Treat equipment as if it were your own and put away as, or better than you found it.  
Contact owner with questions or issues.
Contact owner with questions or issues.


== Restrictions ==  
== Restrictions ==
* Metal and bendable sheet goods only. Do not use on wire.
* For up to 18 gauge steel
* For up to 18 gauge steel
* For up to 16 gauge aluminum
* For up to 16 gauge aluminum
Line 22: Line 19:


= Basic Instructions =  
= Basic Instructions =  
Mark or Score metal along the intended bend<br />
Use clamps to secure sheet to bend with the pressing plate on top. Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.  
Use clamps to secure sheet to bend with the pressing plate on top.<br />
Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.  


== Specifications and Detailed Instructions ==


== Specifications and Detailed Instructions ==
[http://www.harborfreight.com/30-inch-bending-brake-67240.html Harbor Freight 30" Bending Brake]<br />


[[File:Info.jpg|50px|link=]][http://www.harborfreight.com/30-inch-bending-brake-67240.html Harbor Freight 30" Bending Brake]<br />
[http://www.youtube.com/watch?v=L8tTs5lO3mM Good YouTube demonstration of this style brake]
[[File:RTFM.PNG|50px|link=]][http://manuals.harborfreight.com/manuals/67000-67999/67240.pdf PDF Manual]<br />
[[File:Video.jpg|50px|link=]][http://www.youtube.com/watch?v=L8tTs5lO3mM Good YouTube demonstration of this style brake]


= Warnings =
= Warnings =


[[File:Crush.png|100px]] Crush and Pinch Risk
[[File:Crush.png|border|50px]] Crush and Pinch Risk
== Safety ==
== Safety ==
[[File:Goggles.PNG|100px]] Eye Protection Required
[[File:Goggles.PNG|border|50px]] Eye Protection Required




[[category: Equipment]]
[[category: Equipment]]

Revision as of 06:22, 15 February 2013

Zone

Equipment \ Warehouse \ Metal Shop

Owner(s)

  • Randy Farmer

Permissions

For general use by members. Treat equipment as if it were your own and put away as, or better than you found it. Contact owner with questions or issues.

Restrictions

  • For up to 18 gauge steel
  • For up to 16 gauge aluminum
  • Material being bent should be clean and rust free
  • The two c-clamps belong with the brake and should be stored with it

About

For bending thin sheet metal up to 90 degrees.

Basic Instructions

Use clamps to secure sheet to bend with the pressing plate on top. Align both to the leading edge of the supporting plate, tighten clamps, and pull handles on the moving plate to desired angle.

Specifications and Detailed Instructions

Harbor Freight 30" Bending Brake

Good YouTube demonstration of this style brake

Warnings

Crush.png Crush and Pinch Risk

Safety

Goggles.PNG Eye Protection Required