Difference between revisions of "Improve Electrics"

Revision as of 18:09, 29 September 2016

Run electrical to Form1 room (Review existing circuits available above the clean room, may be possible to move this to work we can do based upon existing quad that was in that room's ceiling)
Run electrical to kiln (see 220 items below)

Per Scott, " Pretty sure it's split phase 240. Pretty sure it just needs a 50A split phase outlet to run on 208V at a lower temperature/ramp."

install lights in hallway (need to look to see if there is an existing junction box usable in the attic or hallway, in which case we might be able to do this ourselves)
Install dropped quads in workshop (was: 120v cables to quads in workshop)
220v 50A to front left corner of auto bay (Duplicate of Kiln item above)
220v 30A to large air compressor (in doorway in back wall)
220v 50A drop to welding table
Split metal shop\auto bay lights to their own switch that can be turned on/off from there (we could do this, but well worth having electrician do it while they're working on the 220v in this area)
Run electrical and wire up the two new exterior lights outside the back

hole in outlet above projector (What does this mean? There's a hole in the outlet? Please provide more details.)
inspect for exposed outlets (Not really sure what this means? Outlets without a cover? If so, move to list of items we can do)

Fix electrical to light in kitchen (repair of existing work)
Remove dropped quads from above work tables in front
run electrical to outlets on wall between work tables and admin closet (these are existing outlets, so a repair not new work)
replace removed dropped quads above work tables with outlets at wall for each table (This is existing rough work, so a repair)

@@ Line 37: / Line 37: @@
 :::::* [[Media:Screenshot_20160928-151459.png|Estimate Document]]
- [[Media:20160929_135417.jpg|Sub-panel B]]
+* [[Media:20160929_135417.jpg|Sub-panel B]]
+* [[Media:20160929_135426.jpg|COntents - Sub-panel B]]