Difference between revisions of "Busy Bee Lathe"
| Line 24: | Line 24: | ||
== Electrical == | == Electrical == | ||
'' | The lathe runs on a single phase 240v to 3 phase 240v Variable Frequency Drive mounted to the wall behind it. This allows the lathe speed to be adjusted on the fly by a dial on it's control panel. There are emergency stops wired to the stop button, E-stop button, and brake pedal. It would be real real nice if someone were to copy down the programming settings in the VFD so that if it ever breaks we don't have a hard time replacing it. :) | ||
= Manual(s) = | = Manual(s) = | ||
Revision as of 17:10, 14 November 2021
Owner(s)
- Freeside Atlanta
Permissions
The lathe is one of the more dangerous tools in Freeside, as well as one of the most complex. As-such, do not use the lathe until you've either attended a class on it run by Freeside or have been signed off on it as competent in it's basic use.
Restrictions
- Do not run lathe if oil level below 'low' on sightglass. add pic
- Test emergency foot brake before use
- NEVER EVER EVER attempt to change spindle speeds while machine is running
About
Mechanical Controls
need labeled picture of headstock and apron controls
Setting Spindle Speed
add table See also: Speeds and Feeds
Lubrication System
controls specs, lube type, does the lube pump even work?
Electrical
The lathe runs on a single phase 240v to 3 phase 240v Variable Frequency Drive mounted to the wall behind it. This allows the lathe speed to be adjusted on the fly by a dial on it's control panel. There are emergency stops wired to the stop button, E-stop button, and brake pedal. It would be real real nice if someone were to copy down the programming settings in the VFD so that if it ever breaks we don't have a hard time replacing it. :)
Manual(s)
Instruction and Safety Articles
Projects
Single point threading drive and apron controls need to be refurbished and (re)installed.