Difference between revisions of "Laser Library"

From Freeside Atlanta
Jump to navigation Jump to search
(Created page with "== Acrylic == === 3 mm / 0.11" clear === Power: ? Feedrate: ? === 3 mm / 0.11" opaque === Power: 2.0 Feedrate: 50 mm/min == Cardboard == === 3 mm / 0.11" corrugated ==...")
Line 1: Line 1:
== Acrylic ==
== Acrylic ==
Cast acrylic and extruded acrylic will produce different results. Figures listed below are for extruded acrylic, which is more common and less expensive. If you aren't sure if your acrylic is extruded or cast, it is most likely extruded.


=== 3 mm / 0.11" clear ===
=== 3 mm / 0.11" clear ===


Power: 3.0
Power: ?


Feedrate: 70 mm/min
Feedrate: ?


=== 3 mm / 0.11" opaque ===
=== 3 mm / 0.11" opaque ===


Power: 3.0
Power: 2.0


Feedrate: 70 mm/min
Feedrate: 50 mm/min


== Cardboard ==
== Cardboard ==
Line 22: Line 20:


Feedrate: 200 mm/min
Feedrate: 200 mm/min
== Foam ==
Foams have a much higher tendency to melt and warp from the heat byproduct of the laser, so a higher power setting and faster feedrate is ideal to produce clean cuts all the way through the material.
=== 1 mm / 0.4" craft foam ===
Power: ?
Feedrate: ?
=== 6 mm / 0.23" EVA foam ===
Power: 5.0
Feedrate: 600 mm/min

Revision as of 23:46, 7 September 2014

Acrylic

3 mm / 0.11" clear

Power: ?

Feedrate: ?

3 mm / 0.11" opaque

Power: 2.0

Feedrate: 50 mm/min

Cardboard

3 mm / 0.11" corrugated

Power: 1.0

Feedrate: 200 mm/min